wire saw machine

pecifications

OMC-SJ37quarry diamond wire saw

 The diamond wire saw machine had been tested after long time cutting operation in quarry and improved the mechanical & electrical control system, which can achieve automatic moving controlled by constant tension, and infinitely speed adjustment of main flywheel. The working life of diamond wire is highly increased at the same time. Characteristics:

1. Broad applicability: suitable for all kinds of stone quarry. 
2. High productivity: Cutting depth can reach 20 meters with fast cutting speed, about 2.5~12 m2/h according to different hardness. 
3. Machine can rotate at 360 degree, so it’s workable to cut vertical, horizontal or tilting surface. 
4. Low cost: The cutting surface is smooth with less saw kerf, and without any break, so that waste rate is very low. 
5. Safe and green: the machine is operated separately with low noise and dust, low working intensity and high safety rate. 
6. High automation: the machine can be operated easily by PLC with very simple operation panel.

Suggestions for stationary wire cutting machines:

1.The status of beads wear should be regularly inspected, it should be adjusted once unevenly beads wear happens.

2.The status of wear of joints and beads close to joints should be timely checked, and should be replaced timely.

3. Control the cable tension carefully, set it to 250-350KGS for Φ4.9mm steel cable.

4. Change the linear speed of wire according to materials under cutting, following parameters are for reference only:

Hard granite: 20-25m/s

Medium granite: 22-26m/s

Soft granite: 25-29m/s

Hard marble: 28-33m/s

Soft marble: 30-38m/s

5. The linear speed should be 2-3m/s less than normal cutting speed(standard mentioned above) during the sharpening of new wire saw.